Item: Phanteks Enthoo Evolv Shift Air (v1)
Age: Feb 2020 (bought here)
Price: R500
Payment Method Accepted: EFT
Warranty: Remainder of 5 years although the case mode might void that.
Packaging: Original
Condition: Okay. See pics.
Location: Parkhurst JHB
Reason: Change of scenery
Shipping: Can do. Your cost & risk. Postnet quoted me R240 for counter to counter. Courier should be about the same.
Collection: Sure. Cover all the face holes.
Link: Phanteks Innovative Computer Hardware Design
This case did better at cooling than everyone said it would.
At 21degC ambient and all fans locked at 50%, my GTX1060 6GB maxes out at 72degC running Furmark, Ryzen 3600 hits 83degC running Prime95.
Gaming temps are both 10degC lower than that though.
The Wraith mod involves cutting the support beams out of the side panel as shown in the pic, upping the cooler clearance from the stock 82mm to 98mm. This allows the Wraith Prism cooler to fit with about 1mm of clearance between the cooler and the mesh. Works really well since the cooler is now pulling fresh, filtered air in all the time.
Unfortunately I was a raging idiot and managed to nick the fabric with my Dremel on the first attempt (panel #1), so I though "I'll just put that panel on the back and do the other panel"...then I nicked the other panel too.
I've labelled the panel pics 1 and 2.
FYI
--------
Age: Feb 2020 (bought here)
Price: R500
Payment Method Accepted: EFT
Warranty: Remainder of 5 years although the case mode might void that.
Packaging: Original
Condition: Okay. See pics.
Location: Parkhurst JHB
Reason: Change of scenery
Shipping: Can do. Your cost & risk. Postnet quoted me R240 for counter to counter. Courier should be about the same.
Collection: Sure. Cover all the face holes.
Link: Phanteks Innovative Computer Hardware Design
This case did better at cooling than everyone said it would.
At 21degC ambient and all fans locked at 50%, my GTX1060 6GB maxes out at 72degC running Furmark, Ryzen 3600 hits 83degC running Prime95.
Gaming temps are both 10degC lower than that though.
The Wraith mod involves cutting the support beams out of the side panel as shown in the pic, upping the cooler clearance from the stock 82mm to 98mm. This allows the Wraith Prism cooler to fit with about 1mm of clearance between the cooler and the mesh. Works really well since the cooler is now pulling fresh, filtered air in all the time.
Unfortunately I was a raging idiot and managed to nick the fabric with my Dremel on the first attempt (panel #1), so I though "I'll just put that panel on the back and do the other panel"...then I nicked the other panel too.
I've labelled the panel pics 1 and 2.
FYI
--------
- For your and my protection please read our guide to safe dealing: https://carbonite.co.za/index.php?threads/guide-for-safe-dealing-on-carbonite.131249/
- A deal is concluded for purposes of feedback when parties agree to a deal
Last edited:
