Ko7Ad
Epic Member
Good Day Cudders,
Earlier this year I got my new Mobo, ROG Maximus V, after a lighting strike during the holidays. But before that I had my watercooling setup just cooling my CPU with 1/2" ID piping. The Mobo as far as I have gathered has 3/8" ID barbs. The Problem!
3/8" ID piping will have a 1/2" OD that I could fit into my existing piping and could maybe add some silicone between them or something. The 3/8" ID pipe will thus only be needed to cover the barbs so I can get my 1/2" ID piping over it that way I can keep my 1/2" ID pipe look without reducers and crappy skinny pipes that does not match the rest of the install.
What are your thoughts or experiences?
Thanks!
PS> MODS I MAY HAVE POSTED IN THE WRONG SECTION HERE
Earlier this year I got my new Mobo, ROG Maximus V, after a lighting strike during the holidays. But before that I had my watercooling setup just cooling my CPU with 1/2" ID piping. The Mobo as far as I have gathered has 3/8" ID barbs. The Problem!
3/8" ID piping will have a 1/2" OD that I could fit into my existing piping and could maybe add some silicone between them or something. The 3/8" ID pipe will thus only be needed to cover the barbs so I can get my 1/2" ID piping over it that way I can keep my 1/2" ID pipe look without reducers and crappy skinny pipes that does not match the rest of the install.
What are your thoughts or experiences?
Thanks!
PS> MODS I MAY HAVE POSTED IN THE WRONG SECTION HERE
Last edited: