Good morning all. is there anyone here possibly that would be able to help me out and give advice in programming a DCS PK5508. I would super appreciate it please. Need to change the entry delay.
Hmmm
*8 (installer code default 5555)
Now you will be in system programing
when in programing push 005 on keypad, this will take you to the entry / exit delay section
Entry delay 1 = default 30 sec
Entry delay 2 = default 045 sec
Exit delay = default 60 sec
bell cut off = default 5 Minutes
you cant skip from one to the other so you must start and top and enter values to the bottom for all 4 of the lines, so basically you start at entry delay and stop at bell cut off. and all work with 3 digest values.
so if you want entery delay 1 to be 15 sec you wil enter 015 then keypad will make a accept sound and move to entry delay 2 now you can also enter value 015 keypad will again accept and move to Exit delay set value you want 015 keypad will again accept and move to the last one bell cut off enter value 005" workes in minutes and not seconds like the other values (this is the time it takes for the alarm to turn off the bell when any zone is in alarm)
Now all values are set press the # button couple of times to exit programing
Test and see if it works
