Howsit,
I recently suffered a bit of a short issue causing some stuff to burn.
Did some rewiring, disconnected some stuff, found some wires in the harness that doesn't do anything, etc.
I would like someone to double check the setup and give some general guidance.
I don't want to start it, run and overheat again because I did something stupid.
This is an interesting but easy job.
A 2007 Bantam with '94? Mazda DOHC conversion, so no hectic shiz going on.
Car is in Boksburg.
Thanks for reading
I recently suffered a bit of a short issue causing some stuff to burn.
Did some rewiring, disconnected some stuff, found some wires in the harness that doesn't do anything, etc.
I would like someone to double check the setup and give some general guidance.
I don't want to start it, run and overheat again because I did something stupid.
This is an interesting but easy job.
A 2007 Bantam with '94? Mazda DOHC conversion, so no hectic shiz going on.
Car is in Boksburg.
Thanks for reading